[Aland]

Вот инструкция

Вот описание неисправностей:

Цитата

Problem: No reverse.
1) Tx adjusted incorrectly. Repeat step 5 above.
2) Reverse transistors might be damaged, and unit may require service. See
“Service Procedures.”

Вот степ 5:

Цитата

STEP 5: AUTOMATIC SPEED CONTROL SET-UP
Before you begin this step, the ESC should be connected to the throttle channel
on the Rx, and the Tx should have already been adjusted. Before connecting
the battery pack to the ESC, make sure the ESC switch is turned off.
1) Connect the battery pack to the ESC, and turn on the Tx.
2) NEUTRAL POINT: Make sure the throttle trigger is at the at the neutral
position. Turn on ESC's switch. The green LED will illuminate at this time to
indicate neutral is set.
3) FULL THROTTLE: Pull the throttle trigger to full forward speed position and
hold it until the red LED illuminates, indicating the full forward point is set.
4) FULL REVERSE: Push the throttle trigger to full reverse position and hold it
until both the red and green LEDs illuminate, indicating the full reverse
point is set.
5) The ESC is now set for operation, confirmed by the green LED remaining on.
The ABS braking system is factory set.

Ну а SERVICE PROCEDURES - это в ремонт.