все то же самое только шире диапозон настроек
THROTTLE PARAMETER SETTINGS (Defaults in Bold)
1. MINIMUM BRAKE SETTINGS (10) BLUE LED
Amount of braking applied with first pulse of transmitter throttle information.
>>Raising this setting starts the braking at a stronger/higher level.
Setting (# of flashes) 1 2 3 4 5 6 7 8 9 10
Minimum Brake (%): 0 3 6 9 12 15 18 20 25 30
2. DRAG BRAKE SETTINGS (10) BLUE & AMBER LEDs
Amount of braking applied while transmitter is at neutral. ‘Coast’ brakes.
>>Raising this setting makes the motor slow down more, without
pushing the transmitter’s trigger into the brake/reverse direction.
Setting (# of flashes) 1 2 3 4 5 6 7 8 9 10
Drag Brake (%): 0 3 6 9 12 15 18 20 25 30
3. DEAD BAND SETTINGS (5) BLUE & GREEN LEDs
Space between Minimum Brake & Minimum Drive, with neutral in middle.
>>Raising this setting will increase the ‘free play’, or distance
your trigger must move before forward drive or braking will begin.
Setting (# of flashes) 1 2 3 4 5
Dead Band (%): 2 3 4 5 6
4. MINIMUM DRIVE SETTINGS (5) AMBER LED
Amount of forward drive applied with first pulse of transmitter information.
>>Raising this setting makes the motor start at a stronger/higher
level so it takes off more aggressively from neutral.
Setting (# of flashes) 1 2 3 4 5
Minimum Drive (%): 1 2 5 8 12
5. THROTTLE CURVE SELECTION (3) GREEN LED
>>Changing this setting changes the throttle response and ease
of driveability.
Setting (# of flashes) 1 2 3
Throttle Curve: Linear Expo-1 Expo-2
6. BRAKE FREQUENCY (7) RED LED
>>Raising this setting makes the brake response smoother and
more controllable.
Setting (# of flashes) 1 2 3 4 5 6 7
Brake Frequency (KHz): 1 2 3 4 5 7.5 8
7. REVERSE (2) RED, GREEN & AMBER LEDs
>>Changing this setting activates/deactivates reverse direction.
Setting (# of flashes) 1 2
Reverse (On/Off): Off (FWD/BRK) On (FWD/BRK/REV)
8. MOTOR ROTATION (2) RED, GREEN & BLUE LEDs
>>Changing this setting changes direction of motor rotation.
Setting (# of flashes) 1 2
Motor Rotation (CCW/CW): CCW q CW p
9. battery TYPE selection (3) RED & AMBER LEDs
>>Changing this setting changes the battery pack that is selected
and provides the needed cut-off voltage for Li-Po and Li-Fe packs.
Setting (# of flashes) 1 2 3
Battery Selection Ni-Cd/Ni-MH Li-Po (6.25V) Li-Fe (4.75V)