это основная плата, все провода от мотора, аккумуляторов идут к ней
но достаточно один провод отсоединить от платы, рулевая не подает признаков
находил такую хорошую фотографию этой платы уже подключенной, еще поищу
я боюсь цепь замыкается не с тем чем нужно и именно поэтому идет такой сигнал постоянный, может быть такое?
мог резистор сжечь какой нибудь?
именно эти три указанные мной провода, нашел описание:
These wires lead to the servo positioning sensor.
вот она, аналогичная плата
описание:
A These two connectors are for the Command Logic Light kits.
B These wires lead to the servo positioning sensor.
C These wires lead to the servo motor.
D The Hot or positive terminal for the motor.
E The negative terminal for the motor.
F The FET's (Field Effect Transistors) these regulate the voltage sent to the motor.
G The positive terminal for the batteries located under the chassis.
H The negative terminal for the batteries located under the chassis.
I The crystal which determines which channel your Xmod will run on.