[Aland]

Так настраивал?

Цитата

1. Set the “throttle reversing” switch to the NORMAL
position. (This may need to be reversed on some
brands of radios).
2. Set the “throttle trim” to the CENTER position.
3. Set the “throttle exponential” to MINIMUM or ZERO.
4. Set the “ATV” to 100%.
5. If your transmitter has an adjustable trigger (or stick)
position, move it to the 70/30 position.

Speed Control Programming
NOTE: While in the programming mode, no
power is applied to the motor.
1. Turn on the transmitter’s power switch. (Be sure the
transmitter batteries are fully charged)
2. Turn the ESC switch on.
3. Press and release the set-up button with the included
programming tool. The red and green LEDs will light.
4. Move the throttle to the full throttle position and press
the programming button. The green LED will remain lit
and the red LED will go out. (If the ESC does not sense
throttle movement in 3 seconds by the transmitter, it
will exit the programming mode and you will have to
begin again).
5. Now move the throttle to full reverse and press the
programming button. The red LED will glow and the
green LED will go out.
6. Return the throttle stick to neutral and press the
programming button. The green LED will glow and
the red LED will go out, indicating programming is
complete.
During normal operation, the green LED indicates neutral
and the red LED indicates full forward and full reverse.