1. Install the battery to 2.4G transmitters and shut it down.
2. Insert the matching lines to the channel BIND / CH3 port of the receiver.
3. Connect the receiver battery to VCC port of the receiver, on the same time the two LED are
flashing and this means the receiver are going to the matching status
4. Press and hold the button on the transmitter, and then switch on the power supply.
5. Observe the LED on the receiver, if find that the LED is not flash anymore and that means
successful Matched.(This process will take about 5 seconds)
6. Release the match button on the transmitter, takes out the match line.
7. Install the server and then test.
8. If the tests fail, please repeat the action above.
9. If the tests success, then insert the power supplies port into VCC, match complete.
|