[killermachine188]

@ARCHIbail: Net. Material proshe. Bolsche elektriki. Opis na youtube po angliski:

A short approach of an old idea of mine. No carbon used this time. Components:
- Lineage NQR010A0X4Z, 10A DC/DC converter running at 3V
- 2 4mm not oxidized stainless steel mesh/screen rolls
- 3 spring steel links

Whole construction is running at 9-10A ~ 27-30W . The black foil is used to make the fog visible.

Components needed:
- stain less steel screen/mesh ~63µm
- 3 banana plugs
- 3 pieces of steel spring, 2 shot and 1 long (I took a toy pull car apart)
- 10a or more dc/dc converter 1-6V
- wire
- fan
- fog liquid/juice
- Piece of Wood

1. Drill 5 holes into the wood (I drilled 4mm holes, 8mm space between each other)
2. wire up 2 banana plugs
3. wire up the dc/dc converter
4. cut 2 150x40mm screen strips
5. roll the stript to rolls
6. put the banana plugs into the drilled holes (every second hole, + and - outside)
7. put the rolls into the other holes
8. connect the rolls in serial with the steel spring pieces
9. place a fan
10. put a cup of fog liquid beneath the rolls
11. power up

добавлено через 20 минут
Material sam ne ochen dorogoj. Sobiraetsa ochen bistro i prosto. Esli chtoto slomaetsa, to moshno bistor ortemontirovat. Systema skaliruetsa linearno. W etom primere golova sdelana is 2 trub. Moshno udvojet na 4. Nado budet tolko lish posnat voltag na 6V na dc/dc convertere. Pravda togda nushen Vin min. 7.5V. 2s Lipo budet malo. Ili umenschaem trubi, tak shtobi 4 strubi na 5V rabotalo.
Chtobi demilo proporzionalno nado budet podkluchit sistemu k brushed esc (malenkoj na 15-20A chwatet, moshno is samoletov bes tormosov vsjat) na gaskanale.